MANDREL USAGE FOR
LATHE MACHINE MANUFACTURER
A previously drilled or bored workpiece is held on a mandrel to be driven in a lathe
and machined. There are centre holes provided on both faces of the mandrel. The live centre
and the dead centre fit into the centre holes. A carrier is attached at the left side of the
mandrel. The mandrel gets the drive either through a catch plate or a driving plate. The
workpiece rotates along with the mandrel.
and machined. There are centre holes provided on both faces of the mandrel. The live centre
and the dead centre fit into the centre holes. A carrier is attached at the left side of the
mandrel. The mandrel gets the drive either through a catch plate or a driving plate. The
workpiece rotates along with the mandrel.
There are several types of mandrels and they are:
1. Plain mandrel
2. Collar mandrel
3. Step mandrel
3. Step mandrel
4. Cone mandrel
5. Gang mandrel
5. Gang mandrel
6. Expansion mandrel
A good Lathe Machine Manufacturer uses it to check the accuracy from Chuck to the Center, which is done by the usage of the Dial Gauge, it is in Microns. Preet Lathe Udyog makes sure, it is properly checked to attain the best accuracy
No comments:
Post a Comment